Fit for 81-83 Suzuki GS550/650 Intake Manifold Carb Boot Kit Right &Left 4 Pcs

Specification:
MPN: GL1078CB113CE
Category: Carburetor Intake Manifold Boot
Placement: Intake Manifold
Composition: Metal + Rubber
Colour: Black
Applicable Model:
Fit for 1980-1980 Suzuki GS550
Fit for 1980-1980 Suzuki GS550E
Fit for 1981-1981 Suzuki GS550T
Fit for 1981-1982 Suzuki GS650E
Fit for 1981-1983 Suzuki GS650G
Please refer to the adaptation table for the specific model.
Intake Manifold Definition??
The intake manifold is located between the throttle and the intake valve of the engine. After the air enters the throttle and passes through the manifold buffer, the air flow path is divided here. The intake manifold interface is the interface that connects the intake manifold to the engine block and is installed at the intake manifold port.
Fault Feature:
If the intake manifold interface is broken, it may cause high idle speed, low acceleration, and easy to extinguish when accelerating. Replacing the new intake manifold interface at this point can solve these problems.
Feature:
This product is made of high quality rubber and is durable. It has the advantages of high temperature resistance, high pressure resistance and corrosion resistance.
Installation:
Easy to install, directly replace the old or broken intake manifold interface when installing.
Note: Tools (including other tools such as screwdriver wrenches) may be required. It takes about 30 minutes to an hour. You can also go to the local modification store or garage to install.
Installation Step:
To install the intake pipe, you need to remove the carburetor.
1.First remove the seat cushion, loosen the fixing screws of the air filter, and move the air filter to the rear.
2. then you can easily remove the carburetor, and finally remove the intake pipe.
3. If it is Euro 2 type, the intake pipe screw may need to be removed with an impact screwdriver.
4. There should be a rubber O-ring in the aluminum groove behind the intake pipe. You can replace the original one or replace it with a new one.
5. Do not start immediately after installation, wait until the oil in the oil pipe enters the carburetor and start again.
Package Include:
4??Intake manifold boot
4??Hose clamp
4??Gasket